Sea King 9818-RJ Anleitung zur Fehlerbehebung

11200 Hampshire Avenue South, Bloomington, MN 55438-2453Phone: (800) 982-9920 Fax: (952) 922-8424www.kingcontrols.com1305-SK REV H: MARINE SER

Page 8A

Page 9B

Page 10C

Page 11D

DIRECTV®To receive programming from the DIRECTV 101 satellite only, your receiver must be set forround dish-1 satellite (do this through the receiver’

This page intentionally left blank.Page 13

DISH 500 for DISH NETWORKThe Sea-King will automatically switch between the 110 and 119 satellites for Dish Network byusing the receiver’s remote cont

5. On receiver remote, press MENU 6 1 1.6. Highlight Check Switch and press Select.7. Make sure Superdish and Alternate boxesare NOTchecked.8. Highl

Page 16Note: If using the 61° satellite, choose DISH 1000a.DISH 1000 for Dish Network HDTVThe Sea-King offers a 3-satellite switching feature that al

Page 17OPERATION1. Simply choose your desired channel using the receiver’s remote control. The Sea-Kingwill automatically switch to the appropriate s

Page 18SECTION 6DIRECTV HDTVSATELLITE PAIR SELECTIONUsing the Sea-King controller, select the pair of DIRECTV satellites you want to track based onthe

OPERATION1. Make sure your current region is selected. (See Section 3, OPERATION.)2. Select your satellite pair.Your channels are broadcast from 5 di

Disconnect power supply for 15 seconds, then reconnect.Verify voltage on coax at dome unit is 24 VDC.Inspect rotary joint cable, then reseat (inside d

Verify coax cables are properly terminated with SNAP-N-SEAL®connectors only (see Section 8, REFERENCE).Verify receiver is operating properly.Verify LN

Page 22When a channel from theguide is selected, “Searching for Satellite”appears on the screen.The new channel selected is not found within the curre

Page 23TROUBLESHOOTING BLOCK TIMESTime is listed in minutes.304545Upper Rotary Cable30Tuner (IDB)Display (IDD)RF Box (9762 Series only)Compass Stick30

OPTION 21 RE-INITIALIZE AND 0-RECALIBRATEIMPORTANT! You must call King Controls before performing this procedure.Page 24

Page 25

Page 26TEMPERATURE CALIBRATIONIMPORTANT! You must call King Controls before performing this procedure.

This page intentionally left blank.Page 27

Page 1IMPORTANT!Before performing any warranty work, you must call King Controls for a Service Order Number.TABLE OF CONTENTSSection Contents Page1. I

Page 28WIRING DIAGRAM FOR FLOWCHART9762 Series

Page 29WIRING DIAGRAM FOR FLOWCHART9815, 9818, 1500, 1800 Series

Page 30IMPORTANT!Before performing any warranty work, you must call King Controls for a Service Order Number.Note:Non-warrantable issues are indicated

Page 31

Page 32

Page 33

Page 34

This page intentionally left blank.Page 35

Page 36SECTION 8REFERENCEIMPORTANT! When returning a unit, you must package it in the box from thereplacement unit. Use all included internal packag

Return Shipping Diagram9762 SeriesIMPORTANT! DO NOT OVER TIGHTEN SHIPPING BOLTS.FINGER TIGHTEN ONLY.Note: Some units may have only one shipping bolt

Page 2SECTION 1INTRODUCTIONThe King Controls Service Department is dedicated to providing its dealers and customers with the highest possible level of

1. Carefully lower dish assembly to align shipping bolt hole with hole in chassis.2. Insert shipping bolt thru dish assembly and FINGER TIGHTEN into c

Page 39DOME COVER REPLACEMENT9815, 9818, 1500, 1800 SeriesWhen replacing the dome cover, you must use the same screw or an exact King Controlsreplacem

Page 402 PART REMOVABLE DOME FEET9762-SW & 9762-LP ONLYNewer Sea-King models feature a two part foot. This enables the dome unit to be easily rem

Page 41IMPORTANT! USE ONLY THE COAXIAL CABLES SUPPLIED WITH THE SEA-KING.COIL AND STORE EXCESS CABLE IN THE CABINET WITH THECOMPONENTS. DO NOT CUT CO

Page 42DEFINITION OF AZIMUTH AND ELEVATIONELEVATION: Angle in degrees measured from the ground plane.AZIMUTH: Angle in degrees measured clockwise from

This page intentionally left blank.Page 43

Page 44SECTION 9DIAGNOSTIC PAGESCONTROLLER NAVIGATION

Page 45USER MAIN MENUSerial Number and Software Revision Information

Page 46DIAGNOSTICS: MAIN MENU

Page 47DIAGNOSTICS A: AXIS ANGLES

Page 3SECTION 2WARRANTY INFORMATIONEvery King Controls Satellite System is covered by a TWO YEAR PARTS AND ONE YEAR LABOR limitedwarranty from the dat

DIAGNOSTICS B: BIAS FOR GYROSPage 48

Page 49DIAGNOSTICS C: TUNER DATA

Page 50DIAGNOSTICS D: WIDE SCAN HITS

Page 51DIAGNOSTICS H: MAGNETIC SENSOR

Page 52NOTES:

Page 53NOTES:

Page 54NOTES:

Page 58Service Center Name Customer Name *Address Sea-King Serial Number * / Model SeriesDate of Original Purchase or Installation *Phone No. Make, Mo

Note: This example is for the DTV 101 satellite in Region 2-North Central. The information on your controller willvary depending on the satellite an

11200 Hampshire Avenue South, Bloomington, MN 55438-2453Phone: (800) 982-9920 Fax: (952) 922-8424www.kingcontrols.com®

Page 5Note: Setting the current region reduces satellite acquisition time.SET REGIONREGION OPTIONS:1 NORTH WEST2 NORTH CENTRAL3 NORTH EAST4 CENTRAL W

Page 6SATELLITE LIBRARYDISH 61 Dish Network at 61EXPVU 91 Bell ExpressVu at 91DISH 129 Dish Network at 129DISH 148 Dish Network at 148EXPVU 82 Bell Ex

Page 7ELECTRICAL HAZARD WARNING!The coaxial cable that connects the dome unit to the tuner carries a 24 volt electricalcurrent. Exercise extreme caut